Installation manual

68 | Commission the system
The settings are used for the tack-prevent function. They also applies when the autopilot
is operating in WindNAV mode. Refer to the Operating the autopilot section.
You can select different minimum wind angles for port and starboard. The difference
between port and starboard will be taken into account when calculating the Distance To
Turn (DTT).
Navigation change limit
This parameter defines the maximum course change where the autopilot is allowed to
automatically change the course when the NSO follows a route (NAV steering).
If the required course change to next waypoint in a route is more than the set limit, you
are prompted to verify that the upcoming course change is acceptable.