Installation manual

Commission the system | 53
Commissioning checklist
The NSO has a number of advanced features which can be configured through the
settings menu.
It is recommend you become familiar with the operation of the unit using the default
settings before making any changes to these menus.
Settings menus will vary depending on the optional sensors and devices attached.
Before changing system settings make sure that all displays are powered on as a lot of
settings are global and are shared across the Ethernet network.
It is recommended to note the original settings before making adjustments or changes.
NSO related check list
System
Turn system on for the fi rst time
Confi gure OP40 controller (s)
Set Language
Set Units
Set time
Set Time and Date format
Set power control option if used. Repeat on all relevant displays
Data sources
Perform auto source selection
Perform any manual source set up
Set NMEA0183 baud rate and output sentences. Settings relevant to displays with
NMEA0183 devices attached.
Set up of SimNet groups for parameters such as dimming and alarms
Set up SimNet source selection groups as needed or leave as default. Default is all
parameters are set to SIMRAD group
Any custom setup of devices such as renaming sources. Source select advanced
Calibrate any dock side devices e.g SimNet depth offset
Confi rm Auto pilot interface
Auto Pilot Setup
Dock side setup
• Boat type
• Rudder Calibration (VRF)
• Rudder Test
• Drive voltage
Sea trial
• Compass calibration
• Compass offset
• Boat speed calibration
• Transition speed
• Sea state filter
• Sail boat setups
Echosounder
Set transducer type
Set depth offset
Sea temperature calibration
Speed calibration
Water speed averaging
Radar
Dual Radar support: