Installation manual

Commission the system | 51
Turning on / off: Normal operation
Normal operation mode of turning the unit on /off after OP40s have been configured
POWER ON STAND BY POWER OFF
MOB
ABC DEF
123
JKLGHI MNO
456
TUV PQRS WXYZ
7
STBY
AUTO
PWR
8
0
9
MOB
ABC DEF
123
JKLGHI MNO
456
TUV PQRS WXYZ
7
STBY
AUTO
PWR
8
0
9
PWR
3 s
A quick press of the PWR button will start the system: note it may take a few seconds for
something to appear on the screen.
If you turn the unit ON when no external equipment is connected you will be asked to
run in simulator mode.
When you turn ON the system after the first-time initialization, the system will start with
the same page and with settings that were activated when the system was turned OFF.
Pressing standby will turn off the backlight to conserve
power. All other functions remain in operation.
If the radar is transmitting you can turn it to standby mode
from within the Light dialog.
Note: When turning off the system: The Marine Processor
will take approximately 20 seconds to shut down after the
display has turned off. It is recommended NOT to remove power from the system until
the processor has shut down completely and the OP40 is indicating a red LED
Display control selection: Normal OP40 use
In normal operation mode a green LED indicates which display is being controlled. To
take control of the next display press the DISPLAY key. A short press of the DISPLAY key
will toggle control through to the next assigned Display LED. The OP40 will only toggle
through LED positions that have been assigned to processors.
MOB
DISPLAY
MOB
DISPLAY
MOB
ABC DEF
123
JKLGHI MNO
456
TUV PQRS WXYZ
7
STBY
AUTO
PWR
8
0
9
ht ti
l