Installation manual

46 | Wiring the NSO
BSM-1 Transducer adapter cables
For vessels with existing transducers there are two adapter cables available to assist
with BSM-1 installation.
For vessels that already have an transducer that was used with older Navico products
that has 6 pin connector. Use 000-00022-001 6 pin to 7 pin transducer adapter cable.
These transducers will require the 10 k temp version of the transducer selected for
transducer type in Echo Installation. See the Echosounder Setup section on page 69 for
further information.
3
2
1
6
7
5
4
Blue 7 pin connector
6 pin connector
Connector Pins
(Front View)
Connector Pins
(Front View)
5
4
3
2
1
6
0.7 m (28”)
For other transducers that do not have 7 Pin BSM-1 or 6 pin (above) connector that
require the connector to be removed. Use 000-10046-001 7 pin to bare wire adapter
cable.
5
4
3
2
1
6
7
1. Red Depth +
Wire color
Function
Blue 7 pin connector
Connector Pin
Connector Pins
(Front View)
5. Black Depth -
6. Shield Depth Gnd.
2. Blue Speed signal
3. Orange Speed volts
4. Yellow Temp +
7. Shield Temp -