Installation manual

Wiring the NSO | 37
Ethernet
The NSO system uses an Ethernet network to interconnect high bandwidth devices such
as radar and echo sounder. The NSO marine processor has one Ethernet network port
with an RJ45 connector.
A short RJ45 male to 5 pin female cable
160mm (6") is included with the NSO and
is fi tted to the NETWORK port. This cable
is a cross-over Ethernet cable and will al-
low the NSO to connect directly or via an
NEP network switch to the latest Ethernet
performance modules using the range of
yellow 5 pin Ethernet cables.
Cables are retained by a bayonet type
locking collar.
RJ45 to 5 Pin Ethernet Adapter cable for NSO (Red) crossover 000-10437-001
Pin 1 Pin 8
1
5
4
3
2
5 Pin Yellow RJ45
Pin Func Pin
1 TX + 3 TX +
2 TX - 6 TX -
3 RX + 1 RX +
4 RX - 2 RX -
5NC
Note: For adaptation of the RJ45 connector found on the range of HD radar processors, a
straight through RJ45 male to 5 pin yellow adapter cable is available
RJ45 to 5 Pin Ethernet Adapter cable for HD Radar straight 000-10438-001
Pin 1 Pin 8
1
5
4
3
2
5 Pin Yellow RJ45
Pin Func Pin
1 TX + 1 TX +
2 TX - 2 TX -
3 RX + 3 RX +
4 RX - 6 RX -
5NC