Installation manual

14 | Installing the NSO components
DI10 / DI15 Display Bracket Mount
An alternative to flush mounting the DI10 or DI15 is to bracket mount the display. The
display may be tilted for best possible viewing angle when bracket mounted.
1 Use the lower half of the bracket as
a template to mark the screw hole
location.
2 Drill pilot holes and hole for cables if
required
3 Secure the bracket base to the
surface.
4 Secure the upper bracket to the rear
of the DI Display
5 Tighten the bracket knobs 6 Secure the front bezel fi rmly in
place