Technical data

Page 3Page 2
E03548 Issue 1.0
CONTENTS
1. General
1.1 Introduction
1.2 Technical Summary
2. Operation
2.1 General
2.2 Engaging the Clutch
2.3 Autopilot Mode
2.4 Adjusting Course
2.5 Autotack
2.6 Rudder Movement (Gain)
2.7 Seastate
2.8 Autotrim
3. Configuration
3.1 Scaling
3.2 Calibration Mode
3.3 Adjusting Gain
3.4 Adjusting Seastate
4. Installation
4.1 Fitting Wheelpilot
4.2 Electrical Installation
5. Appendix
5.1 Advice On Operation
5.2 Fault Finding
5.3 Auto Compass Calibration
5.4 Adjusting Belt Tension
5.5 Spares & Accessories
5.6 Service & Warranty
The technical data, information and illustrations contained in this publication were to the best of our knowledge correct at the time of going to print. We reserve the right
to change specifications, equipment, installation and maintenance instructions without notice as part of our policy of continuous development and improvement.
No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, electronic or otherwise without prior permission from Simrad
Navico Ltd.
No liability can be accepted for any inaccuracies or omissions in the publication, although every care has been taken to make it as complete and accurate as possible.
MDL 2/12/98
© 1998 Simrad Navico Ltd
For service and advice please contact the main Simrad dealer in your country of residence.