Instruction manual

Instruction manual

E04596

To select System mode press and hold the TACK and keys

and turn the power on (Fig 5.19) -

The Wheelpilot will beep and all the LEDs will light briefly to

confirm the new configuration.

Please refer to the instructions supplied with the relevant

Command Unit for details on the remote configuring of data

sources.

NOTE If there is more than one data source on the SimNet bus, but

no Command Unit capable of reconfiguring the Wheelpilot

present, the required data source must be the only one present

on the bus when StandAlone mode is selected – power down

or disconnect any multiple sources until after the operation

mode selection process is complete.

NOTE Changing the operation mode, or even reselecting the same

mode, will reset any data source selections that the Wheelpilot

was previously locked onto.

TACK

POWER

Fig 5.19 - Selecting System mode