Instruction manual

WP32 Wheelpilot

E04596

12. Clip the badge to the spoke clamps (Fig 5.8).

Fig 5.8 - Fitting of Wheelpilot

Badge

Wheel nut

Spoke

clamps

Socket

head bolts

Attaching badge

13. Spin the wheel from lock to lock and check that the

Wheelpilot rotates freely and smoothly. If there is any oscilla-

tion at any point of rotation, this is due to the Wheelpilot being

mounted slightly off-centre. Check that the pedestal clamp is

not too low or too high, and that the pedestal mount and the

pilot are exactly parallel to the wheel.

14. Tighten the four socket head bolts on each side of the

pedestal mount, so that the guide rods are held firmly in place.

Do not overtighten.

The Wheelpilot is supplied with a clip-on sun cover (Fig 5.9) to

protect the keypad and control unit from the elements and the

effects of UV light while the pilot is not in use.

Apart from this cover, the Wheelpilot is fully protected from

the elements due to its weatherproof design, and can be left fit-

ted to the pedestal without requiring any additional protection.

Fig 5.9 - Keypad sun cover