Instruction manual

Instruction manual

E04596

Fig 5.6 - Pilot should be central to wheel shaft

7. Fit the Wheelpilot to the pedestal mount by inserting the

two guide rods into the slots on the pedestal mount. Check

that the Wheelpilot ring is centred on the wheel shaft (Fig 5.6) -

Fig 5.7 - Offset rubber spoke clamps

If necessary, reposition the pedestal mount by removing the

pilot and the front plate and loosening the band clamp.

8. With the clutch lever disengaged, rotate the Wheelpilot ring

until the two spoke pillars are at the top.

9. Refit the wheel, ensuring that the top spoke sits between the

two spoke clamps.

10. Two rubber clamps are supplied that fit over the toothed

spoke pillars. The holes in the clamps are offset, so that by

rotating them the gap between the pillars can be increased or

decreased until the wheel spoke is held securely (Fig 5.7) -

11. If necessary, move the Wheelpilot forward, or back along

the guide rods until the wheel spoke fits equally between the

clamps.