Instruction manual

WP32 Wheelpilot

E04596

Fig 5.5 - Attaching clamp using band clamps

Front Plate

Pedestal

Pedestal Mount

Neoprene

Pad

Locate the clamp in the pedestal mount slots to ensure that

there is room to fit the second clamp.

6. Tighten the band clamp as far as possible, until the pedestal

mount is held firmly in place and cannot be moved. Fit the sec-

ond clamp following the same procedure. Fit the front plate,

but do not tighten the four socket head bolts at this point.

3. The exposed section of the band clamps are slotted through

the sleeving provided, which covers the clip and also prevents

it from scratching the pedestal when tightened. It is recom-

mended that the sleeving length is reduced to approx. 25mm

(1.0in) shorter than the length of the band clamps when tight-

ened around the pedestal, to avoid fouling the slots in the

pedestal mount. Note, that if the sleeving has already been fit-

ted to the clamps, it will need to be removed to facilitate fitting.

4. The self-adhesive neoprene pad supplied should be

attached to the inside face of the pedestal mount. This not only

increases the grip of the pedestal mount, but also protects the

pedestal from being scratched by the mount.

5. Slide the sleeving over the band clamps and thread the first

clamp through the pedestal mount (using slots appropriate to

the pedestal), around the pedestal and back in through the cor-

responding slot on the other side of the mount (Fig 5.5) -