Specifications

Simrad MS50 – Chapter 4. Data Service 4.3
Starting from PC
Starting from PC
Procedure
1 Turn on Simrad MS50, see chapter 2. Operation.
2 Open the terminal emulator on the PC, and connect. Key in the
start prompt at+wneradte.
at+wneradte
Terminal MMI started in mode: MMI (multilingual)
CTRL-f to switch font
CTRL-x to return to AT command mode.
Press space to continue
Note!
When using the
terminal emulator,
the data/printer port
(DTE) is
busy and is not
capable of receiving
a data call.
The user is prompted for the 4-8 digit Personal Identification Number
each time Simrad MS50 is switched on:
3a Enter the SIM PIN code, and press ç:
3b If no SIM card is inserted, the "Phone PIN" will be prompted for.
4 During the satellite search, beep tones will be heard in the handset
slow intermittent tones when
searching for any satellite.
rapid intermittent tones when
searching for a specific satellite
(faster when searching for a single
satellite).
5 When receiving a satellite signal, a short tone will sound. If it is an
Inmarsat satellite, a continuous tone will sound with varying frequency
(provided the Tone is ON, see next page).
When closing in on a satellite, the tone should increase in frequency.
Simrad MS50
>SIM PIN: _
Press “Help” for an introduction
470 SIM <Del Ok
Ctrl + T for Help <+U> <+I> <+O> <+P>