Specifications

Simrad MS50 – Chapter 5. Appendices C-15
S-Register commands
S-registers are special memory locations in the Simrad MS50 for
storing specific configuration and operating parameters.
AT S0 =
[n]
ç
specifies automatic answer at the n
th
ring.
0=OFF, 1-255=ON.
AT S0 =
<n>
ç
sets value of register.
AT S0 ? ç
displays current value of register.
Default
AT S0 =0 ç turns automatic answer OFF.
AT S0 =1 ç answers after 1 ring.
the Simrad MS50 ASD will terminate incoming calls
after 95 secs.
AT S2 =
[n]
ç
stores the ASCII decimal code for the escape character.
Authorized codes within: 0 to 255.
n
≥ 128 disables the escape sequence.
AT S2 =
<n>
ç
sets value of register.
AT S2 ? ç
displays current value of register.
Default
AT S2 =43 ç sets the ESCAPE code to
43 (
+-key).
AT S3 =
[n]
ç
stores the ASCII decimal code for the carriage return
character. Authorized codes within: 0 to 127.
AT S3 =
<n>
ç
sets value of register.
AT S3 ? ç
displays current value of register.
AT commands cont’d
Appendix C – AT commands cont’d