Specifications

Simrad MS50 – Chapter 5. AppendicesC-6
Extended AT commands
AT & C
[n]
ç
determines the Data Carrier Detect (DCD) behaviour:
AT & C0 ç sets DCD always ON.
Default
AT & C1 ç sets DCD, only when connected.
AT & D
[n]
ç
selects the Data Terminal Ready (DTR) behaviour:
AT & D0 ç the Simrad MS50 ASD ignores
DTR.
AT & D1 ç the Simrad MS50 ASD enters
Online Command Mode when DTR goes inactive.
Default
AT & D2 ç the Simrad MS50 ASD clears
call when DTR goes inactive.
AT & F ç
resets the Simrad MS50 ASD to factory default. The
factory default is not saved as with the AT&W command,
so ATZ revokes to last saved values.
AT & S
[n]
ç
selects the Data Set Ready (DSR) behaviour:
Default
AT & S0 ç sets DSR permanently ON.
AT & S1 ç sets DSR ON when satellite link
is established.
AT & V ç
displays stored configuration profile.
AT&Wç
saves active configuration profile.
(May be recalled using
AT Z ç).
AT commands cont’d
Appendix C – AT commands cont’d