Installation manual

| 13
Wiring | 10kW and 25kW Installation Manual
5. Carefully unwrap the copper tape (1) and black PVC tape (2). Shorten
both the foil shield (3) and the clear insulation material (4) so that an extra
50mm of cable is exposed. Re-use the copper tape on the end of the foil,
ensuring it is stuck to the same side as before, to ensure good conductivity.
ggy
1
2
3
4
50mm
6. Pass the scanner cable through the cable gland opening, into the pedestal.
7. Connect the  ve scanner cable connectors to the ‘J’ connectors as follows:
Cable Connector Pedestal Connector (on PCB)
P1 J1
P2 J2
P3 J3
P4 J4
P5 J5
8. Use the cable clamp (1) to secure the cable to the upper housing. The clamp should hold the
cable at the point where it is wrapped in copper tape.