System information

Operation | 11
for operation of NFU steering levers or remote controls.
Alternative displays in Standby mode
Alternating rudder angle bargraph
If your autopilot is driving a Simrad
MSD50 Stern Drive, the rudder
angle display will after turn-on
alternate between 10 degrees port
and starboard to indicate that the
(rudder) zero point need be set.
Refer to page 107 to set the zero point.
No rudder angle bargraph
When the autopilot is operating on
Virtual Rudder Feedback (VRF), the
rudder angle bargraph is empty in
Standby mode.
No mode indication
When the autopilot is configured for
Electronic Vessel Control (EVC), you
can take manual control of the
steering by means of the helm
irrespective of the autopilot mode.
The autopilot will go to Standby
mode. The “S” in the display is
replaced by a dash to indicate that
steering is from the helm.
Ref. page
109.