Instruction manual

Installation

20221586F 81

On-Off

Vsys+

AUTOPILOT COMPUTER

MAIN PCB

ROBNET

Bus+

Vsys

Bus

Pnk Gry

Yel

AP26

CONTROL UNIT

REAR VIEW

TB15

Connect to

any of the two

Robnet2

connectors

Figure 3-11 Control unit connection

J1 and J2 (left) are Robnet2 connectors. J3 and J4 are SimNet

connectors.

AP27 connection

If a Simrad AP27 is part of the system, use the JP27 Jack Point

and connect as shown on

Figure 3-9. Alternatively cut the

connector from the cable and connect the wires in parallel with

the cable shown on

Figure 3-11 using the same color code.

Note ! The AP27 cable contains an air-breathing tube. Check that the

tube is open after you have cut the cable.

3.13 RC36 Rate Compass installation

Figure 3-12

RC36 mounting

The heading sensor is the most important part of the autopilot

system and great care should be taken when deciding the