Instruction manual

Simrad AP26 and AP27 Autopilots

58 20221586F

Water temperature

Select the source for water temperature (normally the

same as the source providing depth data).

DisLog

Select the Log source.

Depth

Select the source for depth data.

Course Adjust

When using the

(PORT) or (STBD) buttons in

AUTO mode, you are changing the set course in 1°

increments. If you prefer the increments to be 10°

each press (does not apply for sailboats), proceed as

follows:

Select Course adjust and turn the course knob to change the

setting. The default value is 1°, which is the preferred setting.

Select 10° if you want to make major course changes in 10°

increments with the buttons and fine-tune the set course with the

course knob.

Turn Pattern Select

Note ! Only available for power boats (planing, displacement or

outboard)

Select the turn pattern(s) to be available under the

TURN/DODGE/INFO button. U-turn is always

available. Step through the list of turn patterns by

using the PORT or STBD button. Select the wanted

pattern by rotating the course knob to fill the squares.

Available turn patterns are: U-turn, C-turn, Spiral,

Zigzag, Square, Lazy S, Depth (contour).