Instruction manual

Operation
20221586F 57
Manual source select
Step through the list of sources using the PORT or STBD
button. Select wanted source by rotating the course knob.
– – indicates that no source is supplying the data available.
Notes !
1. Simrad products will be identified by the product name
provided the data is available on SimNet. If data is
provided via an NMEA0183 port on the autopilot
computer, the display will read NMEA-1 or NMEA-2.
NMEA2000 products will have a special ID.
2. See note on page
90 and note 3 below.
3. In the event the SimNet is not powered on, sources
supplying data to SimNet are not on or malfunctioning, or
there is no SimNet installed, it is possible to use any
control unit in the system to select NMEA sources. The
source select displays are then available on all control
units.
Compass
Select the compass to be used if more than one
compass is connected.
Note! Compass can only be selected in STBY mode
NAV source
Select a source for NAV mode steering.
Position
Select the source for position data and NoDrift mode.
Wind Angle
Select the source for Wind Angle.
Wind Calculated
Select the source for Calculated Wind data for the
Simrad group. The autopilot uses internal sources
irrespective of the selected source.
Water Speed
Select the source for water speed (normally the same
as the source providing Log data).