Instruction manual

Operation
20221586F 23
After turn on the rudder angle
display will alternate between
10 degrees port and starboard to
indicate that the "rudder" zero
point need be set.
Use the wheel to bring the "rudder" to midship position. Turn the
wheel from lock to lock (H.O. to H.O.) and count the exact
number of turns. Then start from one lock position and turn the
half number of turns.
Press AUTO and then STBY. The zero point is now set and the
display will show:
Follow the operating
instructions on the following
pages. There is no further need
for zero point settings until next
time you turn the autopilot on.
2.4 Follow-Up steering (FU)
Note ! Not applicable for Virtual feedback configuration (page 68).
In the Follow-Up steering mode the course knob may be used to
set rudder commands. The commanded rudder angle is shown on
the display and the rudder will move to the commanded angle
and stop.
Press both
buttons
simultaneously
to activate
Follow-Up
Use course
knob to
command
rudder angle
Commanded rudder angle 7° to port.
Rudder angle: 4° to port and moving.
Return to manual control in Standby by pressing
the STBY button
WARNING ! While in Follow-up mode you cannot take manual control
of the wheel.