Instruction manual

Operation
20221586F 21
2.2 ON/OFF - Standby mode
Note ! At first time turn on see paragraph 4.1.
A single press on the STBY button switches the system ON and
the following status displays are shown:
Autopilot computer model
P00 M00 S000
AC20
Simrad
Self check
Power board revision
Main board revision
Autopilot model
HW rev. 00
SW 1.2.01
AP26
Simrad
Hardware revision
SW 1.2.01
Software version
Software release
Software release
Software version
Sn xxxxxx
SimNet no.
SW and HW revisions shown are examples only.
After approximately 5 seconds, the system is operative and the
unit that was turned on will show the Standby mode display.
Other units in a multistation system will display "Inactive".
Control is transferred to any single unit by pressing its’ STBY
button.
When the autopilot operates
on Virtual feedback, the
numerical indication of the
rudder angle is omitted.
The main Standby mode display
shows.
−
Standby mode
− Current heading 345°M
− Compass source: Rate
compass
− Rudder angle =00°.
Alternatively, the Standby mode
display can show the mode
index and current heading by a
long press on the
TURN/DODGE/INFO button.
Refer to INFO menu, page
62.
Note!