Instruction manual

Configuration and Setup
20221586F 135
steps with respect to the reading set during the automatic
rudder test (page
106). Always perform a new Autotune after
the adjustment.
• Provide the owner with user training.
Providing user training
The user should be instructed in the "basic" operational
functions, such as:
• Turning the system on and off
• Changing modes. Explain briefly what takes place in the
different modes.
• Regaining manual control from any mode. Point out in what
modes the helm is engaged by the autopilot (bypass/clutch).
• Taking command at an "inactive" station, if applicable.
• Using the lock mode, how to lock/unlock and how to shut the
system down from a locked control unit, if applicable.
• Use of the Non-Follow-up and Follow-up steering modes and
learning the difference between the two.
Note ! No Follow-up mode when configured for Virtual feedback
• Use of a Non-Follow-up and Follow-up controller, if
connected.
• Changing course by rotary knob and buttons.
• Stepping through the User Set-up Menu learning how to (and
why to) change the settings.
• How to select alternative sources for heading (compass),
navigation (GPS, chart plotter), speed, depth etc. if available.
• Understand the difference between NAV mode and NoDrift
mode and their data sources (Nav, Pos).
• Locating compasses and knowing to keep magnetic items
away.
• Locating the Mains circuit breaker and the separate SimNet
circuit breaker if provided.
• Knowing the use of thrusters with the autopilot.