Instruction manual

Simrad AP26 and AP27 Autopilots
132 20221586F
confirm this by rotating the course
knob clockwise.
Verify that the hardware is OK. If
not, replace the corresponding
PCB(‘s).
Proceed to the SimNet Setup menu by pressing the STBD
button, or press STBY to return to normal autopilot operation.
SimNet setup
Under Service in the Installation
Menu, select Simnet setup by
pressing the STBD button and
confirm this by rotating the course
knob clockwise.
Sn 00000 is the unique SimNet ID
number for the specific autopilot
control unit.
Group selection
SIMRAD: Autopilot is part of the
Simrad Group. Source selection
will be common for the products
in the group (synchronized).
STAND ALONE: Source
selection for the autopilot will not
be transferred to other products in
the Simrad Group (no
synchronization).
Backlight Illumination
Set backlight to synchronize with
one of the illumination banks (1-
3) available on the SimNet, or to
STAND ALONE for individual
control of the autopilot
illumination.