Instruction manual

Configuration and Setup
20221586F 129
Recall Autotuned?
To recall the parameter values that
were achieved during the
Automatic tuning procedure,
rotate the course knob clockwise.
When parameter values are
recalled, Confirmed is displayed.
Exit the Parameter menu by pressing STBD button to proceed to
the Service menu, or press STBY to return to normal autopilot
operation.
4.9 Service Menu
Select STANDBY mode and then enter the Installation Menu by
pressing and holding the NAV/WIND/SETUP button for 5
seconds. Select “Service” by pressing the STBD button and
confirm by rotating the course knob clockwise.
System data and SimNet/NMEA
data are test functions to analyze
data processed by the autopilot.
To exit the menu, press any mode
key (STBY, AUTO or NAV).
System Data Menu
Select System data by rotating the
course knob clockwise.
Step through the menu by pressing
the STBD button. The menu
provides you with additional
system data that can be useful when
testing or trouble shooting the
system.
Steer compass
Steering Compass readout,
M=Magnetic, T=True
Rudder
Rudder angle. Normally between
zero and 45 degrees.