Instruction manual

Simrad AP26 and AP27 Autopilots
114 20221586F
The Rudder test is verified by the
display showing ‘Motor OK’ or
‘Failed’. If ‘Failed’ is given, check for
correct electrical connection.
When test is finished the display will
read:
Drive Engage
See page
108
4.5 Interface Settings
Sets the format of the clock/data output for radars connected to
the Autopilot Computer.
Step to the Interface part of the
Installation Menu.
Turn the course knob clockwise to
access the Interface Setup items.
Use the course knob to select the
connected type of radar.
Note ! This setting is not available in the AC10 Autopilot Computer.
4.6 Display units
Select Display units by pressing
STBD button and confirm by rotating
the course knob clock-wise. This
screen gives access to the display unit
set-up of the Wind Speed, Sea
temperature and Depth. The setup is
local to each control unit.