Instruction manual

Configuration and Setup
20221586F 113
The next step is to enter the correct
direction of the rudder movement.
Press and hold the
TURN/DODGE/INFO button.
Observe the rudder movement.
Release the button after 3 seconds.
If the rudder is not moving so as to
give a starboard turn, press and hold
the TURN/DODGE/INFO button for
another 3 seconds.
When the rudder is moving to
starboard, turn the course knob
clockwise to confirm.
While observing the rudder, use the
wheel to turn the rudder hard over to
starboard position. Turn the wheel
carefully a little to port just to release
the hydraulic pressure. When ready
confirm by turning the course knob
clockwise
Press and hold the
TURN/DODGE/INFO button.
Release the button when the rudder
reaches the port hard over position.
The rudder will now be automatically
centered.
Note ! The reading in the rudder angle display is not showing a rudder
angle, only the direction of the rudder movement.