Instruction manual

Configuration and Setup
20221586F 101
Each group is designed to focus on specific functions and enable
quick access when changes need to be made.
Some important points regarding the installation settings:
• When the autopilot is delivered new from the factory AND
ANY TIME AFTER A MASTER RESET OF MEMORIES
HAS BEEN PERFORMED, the installation settings are all
reset to factory preset (default) values. The automatic
interface prompt will appear (see page
99) and a complete
setup has to be made.
• The values that are selected from within the Installation
Settings Menu, are stored in the memory of the autopilot
system. No specific action is required to "SAVE" the selected
values. Once the value is changed, it is stored until the next
time the menu item is selected and changed.
• The Installation Settings are global except for display units
and language, enabling settings to be distributed to all control
units in the system.
• The Seatrial settings are dependent on successful completion
of the Dockside settings.
4.3 Installation Menu
The Installation Menu is
presented on the autopilot
display by pressing and holding
the NAV/WIND/SETUP button
for 5 seconds.
Note ! The INSTALLATION MENU is different from the USER SETUP
MENU. Refer to the flow diagram on page
103 for a pictorial
view of the Installation Menu.
Navigate through the Installation Menu as follows:
• Answer YES to a question by rotating the course knob
clockwise.
• Answer NO to a question or proceed to the next menu item by
pressing the STBD button.
• Return to the previous menu item by pressing the PORT
button.