Instruction manual

Simrad AP26 and AP27 Autopilots
100 20221586F
“SEARCHING” is flashing as long as the
autopilot is searching for data. When the
automatic interface setup is finished, “Done
press →” is displayed. Press the STBD button to
accept. The display will read “SETUP
REQUIRED”.
Continue with the installation setup according to
the next chapters.
If you already have completed the installation
settings, the autopilot will enter STBY mode.
4.2 Description of Installation Settings
Note ! The installation settings must be performed as part of the
installation of the autopilot system. Failure to do so correctly
may prohibit the autopilot from functioning properly!
The Installation menu can only be accessed in STBY mode.
The Installation Settings are grouped into the following
functional categories:
• Language: Selection of language used for display
information
• Dockside: Items to be set prior to sea trials
These will vary depending on the type of
feedback the autopilot will use (page
68, 104,
111)
• Interface: Setting the format of the clock/data output for
radars connected to the Autopilot Computer.
• Display units: Setting the units to be displayed for wind
speed, water temperature and depth.
• Sea trial: Presents settings and automatic calibrations to
be performed during sea trial.
• Parameters: Permits viewing and changing of basic
steering parameters (See also response control
page
59).
• Service: System data, NMEA data, NMEA test,
SimNet setup, Master reset of memories.