Installation manual

Simrad ES60
Temperature s ensor interface
The ES60 Fish finding echo sounder will accept input from an
analogue temperature sensor.
If more than one transceiver is used by the echo sounder system,
the temperature sensor is connected to only one of them.
Wiring procedure
1 On the E S60 Fish finding echo sounder, connect the
positive signal from the sensor to pin 4 on the
Auxiliary
connector on the General Purpose Transceiver.
2 Connect the ground signal from the temperature sensor to
pin17onthe
Auxiliary connector.
Setup procedure
1 On the ES60, access the Install menu, and open the
Temperature sensor dialogue box.
2 For
Source selection, select Analog input.
3 Select which transceiver you have connected the
temperature sensor to.
• When the sensor is operational, you will be able to
follow the temperature readings in the dialogue box.
Related topics
GPT external sensors on page 60
Output interfaces
The following interfaces are set up to transmit information to
external devices.
• Sonars
•Depth
Sonar system interface
The current depth from a defined transceiver channel can be sent
out on a serial line to a sonar system. You can only use the serial
lines already set up to accept input from other peripherals. One
or more of the following serial lines can be used:
• Heave Sensor
• Navigation Interface
• Trawl Interface
Note that the depth information is normally also provided on the
duplex interfaces to trawl instrumentation and catch monitoring
systems.
92
304699/A