Installation manual

Interfaces and integration

2 On the ES60 computer, connect the receive signal Rx on

pin 2, t he transmit signal

Tx on pin 3, and ground on pin 5.

3 On PI44 and PI54, use either connector

NMEA1 or NMEA2.

Connect the receive signal

Rx on pin 8 , the transmit signal

Tx on pin 6, and ground on pins 7 and 9.

4 On PI30 and PI32, use connector

NMEA. Connect the

receive signal

Rx on pin 3 , the transmit signal Tx on pin 1,

and

ground on pins 2 and 4.

5 Ensure that the length of the cable does not exceed

approximately 50 meters. If a longer cable is required, you

may need to use buffer ampliﬁers on the serial li ne.

Setup procedure

1 On the ES60, access the Install menu, and open the Purse

Interface

dialogue box.

2 Click the

RS232 button to open the RS232 Setup dialogue.

3 Enter the identiﬁcation of the RS-232 port you have used

to make the connection.

4 Enter the correct comm

unication parameters, and click

OK.

5 Ensure that the transmit parameters on the PI system

matches t he receive parameters on the ES60.

6 Click the

Depth output button to open the Depth Output

dialogue.

7 Click

Depth output to enable the communication.

8 For

Telegram, select $SDDBS.

9 Click

Ok to exit the Depth Output dialogue.

10 Click

Ok to exit the Purse Interface dialogue.