Installation manual

Simrad ES60
2 On the ES60 computer, connect the receive signal Rx on
pin 2, t he transmit signal
Tx on pin 3, and ground on pin 5.
3 On the ITI transceiver, use connector
Serial A. Connect the
receive signal
Rx on pin 2 , the transmit signal Tx on pin 3,
and
ground on pin 5.
4 Ensure that the length of the cable does not exceed
approximately 50 meters. If a longer cable is required, you
may need to use buffer amplifiers on the serial li ne.
Setup procedure
1 On the E S60, access the Install menu, and open the Trawl
Interface
dialogue box.
2 Click the
RS232 button to open the RS232 Setup dialogue.
3 Enter the identification of the RS-232 port you have used
to make the connection.
4 Enter the correct communication parameters, and click
OK.
5 Ensure that the transmit parameters on the ITI matches the
receive parameters on the ES60.
6 Click the
Depth output button to open the Depth Output
dialogue.
7 Click
Depth output to enable the communication.
8 For
Telegram, select $SDDBS.
9 Click
Ok to exit the Depth Output dialogue.
10 Click
Ok to exit the Trawl Interface dialogue.
Related topics
Generic RS-232 Serial line cable on page 47
Cable between ITI and echo sounder on page 64
Catch mon itoring system interface
Communication with the Simrad PI Family catch monitoring
systems is based on NMEA telegrams. This is a two-way serial
communication line, and the following information is normally
exchanged:
• From ES60 to PI: Sounder depth below surface ($SDDBS
telegram)
• From PI to ES60: Data output (PSIMP,D)
The PI system can export other information as well, but only the
mentioned data can be processed and used by the echo sounder.
Wiring procedure
1 Locate a free RS-232 serial port that can be used to connect
the PI system.
88
304699/A