Installation manual

Simrad ES60
The following basic configurations exist:
• One transceiver: Use a “crossover” cable between the
computer and the transceiver
• Two or more transceivers: Use “straight” cables between the
computer and the Ethernet switch, and between the switch and
the transceivers.
Wiring procedure, one transceiver
1 Locate the Ethernet port you wish to use on the computer.
2 Connect a “crossover” cable from the computer’s Ethernet
socket to the socket on the General Purpose Transceiver.
Wiring procedure, two or more transceivers
1 Locate the Ethernet port you wish to use on the computer.
2 Install an Ethernet switch.
3 Connect a “straight” cable from the computer’s Ethernet
socket to the “uplink” socket on the Ethernet switch.
4 Connect “straight” cables from Ethernet switch’s remaining
sockets to each of the General Purpose Transceivers.
Setup procedure
Note that you will only need to carry out this procedure if you set
up an echo sounder system using a locally purchased computer!
1 On the ES60, exit the echo sounder program, and access
the
Desktop.
2 Click the
Start button in the bottom left corner of the
desktop. On the menu, select
Settings,andthenControl
Panel
.
3 On the
Control Panel, select Network connections.
4 Double-click on
Local Area Connection to open the Local
Area Connection Status
dialogue box.
5 At the bottom of the dialogue, click
Properties.
6 In the
Local Area Connection Properties dialogue, select
Internet Protocol (TCP/IP), and click Properties.
7 Observe that the
Internet Protocol (TCP/IP) Properties
dialogue opens.
8 Click
Use the following IP address, and enter I P address:
157.237.14.12.
• Observe that the Subnet mask and Default gateway
addresses appear automatically. You do not need to
change these.
9 Click
Ok to exit the Internet Protocol (TCP/IP) Properties
dialogue.
86 304699/A