Installation manual

Simrad ES60

INSTALLATION PROCEDURES

This chapter provides the basic information required to install

the physical units.

Note

Physical installation of commercial units (computers, printers,

displays) is n

ot described in this manual. Refer to the applicable

user manual(s) provided with the product.

Topics

Basic procedure on page 26

Conﬁguration on page 27

General P urpose Transceiver installation on page 31

ES60 Marine Computer installation on page 33

Basic procedure

This is the basic installation procedure.

1 Check t hat you have received all parts required for the

installation; cables, connectors, brackets etc.

2 Install the transducer(s) and the transducer cables according

to the guidelines in this manual and the drawings provided

with the transducer.

3 If applicable, install the two-wire cable for the temperature

sensing thermistor.

4 Mount the Processor Unit (computer) and the display using

the appropriate brackets.

5 Connect the computer and display cables:

• Power cable to display monitor.

• Power cable to computer.

• Video cable from computer to display monitor.

• Connect the pointing device (mouse or trackball)

6 Mount the General Purpose Transceiver using the

appropriate brackets.

7 Connect the cables:

• Transducer cable(s)

• Power cable(s)

• If applicable, connect the cable from the temperature

sensor.

• If available, install a two-wire cable for remote on/off of

the General Purpose Transceiver(s).

304699/A