Installation manual

Simrad ES60

Storage after unpacking

The unit must whenever possible be stored in its original

transportation crate until ready for installation. The crate must

not be used for a ny purpose for which it was not intended (eg.

work platform etc.).

Once unpacked, the equipment must be kept in a dry, non

condensing a tmosphere, free from corrosive agents and isolated

from sources of vibration.

Note

Do not break the seal to open a circuit board package before

the board is to be used. If the board package is returned to the

manufacturers with the seal broken, the contents will be assumed

to have been used and the customer will be billed accordingly.

The unit must be installed in its intended operating position as

soon as possible after unpacking. If the unit contains normal

batteries, these may have been disconnected/isolated before the

unit was packed. These must then be reconnected during the

installation procedure. Units containing batteries are marked.

Note

Units containing lithium or alkaline batteries must be handled

separately and with care. Such units are marked accordingly. Do

not attempt to recharge such batteries, open them or dispose of

them by incineration. Refer to the applicable product data s heets.

Storage after use

If a unit is removed from its operating location and placed into

storage, it must be properly cleaned and prepared b efore packing.

Cleaning cabinets

If a cabinet has been exposed to salt atmosphere while it was in

use, it must be thoroughly cleaned both internally and externally

to prevent corrosion.

1 Wipe the cabinet externally using a damp cloth and a little

detergent. Do not use excessive amounts of water as the

unit may not be water tight. On completion, dry the unit

thoroughly.

2 All surfaces must be inspected for signs of corrosion,

ﬂaking/bubbling paint, stains etc. Damaged or suspect areas

must be cleaned, prepared and preserved using the correct

preservation mediums for the unit. The mediums to be used

will usually be deﬁned in the units’ maintenance manual.

304699/A