Installation manual

Simrad ES60
Hull with flat bottom
If the vessel’s hull is flat you do not need a fairing. The
transducer is then be bolted directly to the hull using two bronze
or stainless steel bolts (I) and a cable bushing. Note that the
cable bushing must be mounted with proper gaskets (4) under
and over the hull, as well as sealing c ompound (J) around its
body. Also, fill the bolt holes with a filling compound to ensure
a smooth transducer surface.
C
J
I
F
4
3
(CD017007C)
(C) = Filling compound
(F) = Forward
(I) = Threaded rod with nuts and washers, or bolt
(3) = Washer
(4) = Rubber gasket
118
304699/A