Installation manual

Installation Manual
20222006 / Rev. A 33
Replacing a SimNet Class 1 product with a
similar product
The interface and source settings on the replacement product
must be cleared by a Source Reset or a Master Reset (like a new
product) prior to connecting it to SimNet.
When connected to the active SimNet the product will ask you to
“Start” the automatic Source selection. If there are other Class 1
products on the network it will automatically adapt to the
existing Simrad group setup and join in as a data source.
If there are no other Class 1 products on SimNet, the replaced
product will make a normal automatic source selection as
described on page 28.
Replacing a SimNet class 2 product with a
similar product
In a Class 1 system
The replacement product will automatically adapt to the Simrad
group setup on SimNet. If it is meant to work as Stand alone it
must be set up manually as in a first time installation (page 26).
In a Class 2 system
The replacement product shall normally be setup as if it was a
first time installation (page 28). Some products on the network
may need a Source Reset to detect the replaced product as a
source.