Installation manual

Simrad SimNet
32 20222006 / Rev. A
Class 2 product to Class 1 system
1. It will adapt to the Simrad group source selections that are
already made and use and present appropriate data.
2. If the added product is source for a DataType that has not
been available on SimNet, it will automatically be
selected by the Class 1 product(s) and added to the
Simrad group as a source
3. If it is a second source for a DataType already available
on SimNet it will not
be automatically selected. You have
to make a manual selection on a Class 1 product in the
system to make it a source.
Class 2 product to Class 2 system
1. The new Class 2 product will automatically select the first
available data source for each DataType it needs.
2. If the new product is source for a DataType that has not
been available on SimNet, it will automatically be
selected as a new source by the other Class 2 products.
3.8 Replacing a defective unit with a similar
unit
It is important to observe the instructions below because SimNet
identifies each source as an individual one. It will not
automatically accept a replacement source even if the DataType
is identical.
Replacing an active transducer
Class 1 system
The replaced source is automatically selected from a Class 1
product by activating the Source Update function or by manual
selection in the source select menu. All products in the Simrad
group will be automatically updated. Standalone products must
be set up individually.
Class 2 system
Other products on the network may need a Source Reset to be
able to detect and utilize the new source.