Installation manual

SimradPI50
•ReceivesignalRxonpin2.
•TransmitsignalTxonpin3.
•CommonGroundonpin5.
→GenericRS-232Seriallineonpage35
→GenericRS-232Seriallineonpage36
cOntheGPSsystem,wireasdescribedintherelevantdocumentation.
dEnsurethatthetotallengthoftheseriallinecabledoesnotexceed
approximately50meters.
Ifalongercableisrequired,youmayneedtousebufferampliersonthe
serialline.
2ConnectthePI50totheGPSsystemusinganEthernetline.
aLocatetheEthernetportyouwishtouse.
IfnoEthernetportisavailable,anEthernetswitchmaybeinsertedbetweenthe
computerandthetransceiver.
bConnectanEthernetcablefromthePI50computertotheperipheralsystem.
WestronglyrecommendthatyouusehighqualityEthernetcables,minimum
CAT-5.
→RJ45Ethernet,straightonpage43
3ClicktheSetupiconundertheMainmenutoopentheSetupmenu.
4ClickNavigationtoopentheNavigationdialog.
5Foreachtab:
aSelectwhichporttouse.
bClickSetupfortheselectedporttodenethecommunicationparameters.
cSelectwhichNMEASentencetouse.
IfyouchooseAuto,thePI50willautomaticallychooseamongtheincoming
informationaccordingtoapredenedprioritylist.
dIfapplicable,denetheTalkerID.
6ClickOKtosavethecurrentsettingsandclosethedialog.
62
328459/B