Installation manual

SimradPI50
•ReceivesignalRxonpin2.
•TransmitsignalTxonpin3.
•CommonGroundonpin5.
→GenericRS-232Seriallineonpage35
→GenericRS-232Seriallineonpage36
cOntheechosoundercomputer,useasimilarseriallineoutput.Connectthe
RS-232cableasfollows:
•ReceivesignalRxonpin2.
•TransmitsignalTxonpin3.
•CommonGroundonpin5.
Note
Rememberthatthet r a n s m i t signalontheechosoundercomputeristher e c e i v e
signalonthePI50computer .SeeGenericRS-232Seriallineonpage35.
→GenericRS-232Seriallineonpage35
dEnsurethatthetotallengthoftheseriallinecabledoesnotexceed
approximately50meters.
Ifalongercableisrequired,youmayneedtousebufferampliersonthe
serialline.
2ClicktheSetupiconundertheMainmenutoopentheSetupmenu.
3ClicktheInstallationbuttontoopentheInstallationsub-menu.
Onthesub-menuI/OSetuptoopentheI/OSetupdialog.
4IntheI/OSetupdialog,selectwhichseriallinetousetoacceptthedepthinformation.
5Clickonthechosenporttoselectit,thenclicktheInputbuttontoopentheSelect
Inputsdialog.
6IntheSelectInputsdialog,locateEchoNMEAontheleftside,andclickthe[►]
buttontoconnectit.
7ClickOKtosavethecurrentsettingsandclosethedialog.
8IntheI/OSetupdialog,clickonthechosenporttoselectit,thenclicktheSetup
buttontoopentheSerialPortSetupdialog.
9IntheSerialPortSetupdialog,entertherelevantparameterstosetuptheport.
→StandardNMEA0183communicationparametersonpage105
60
328459/B