Operation Manual

6 Maintenance
6.1 General maintenance
The IS20 instruments are “repair by replacement” units,
and the operator is therefore required to perform only a
very limited amount of preventive maintenance.
If the unit requires any form of cleaning, use fresh water
and a mild soap solution (not a detergent). It is
important to avoid using chemical cleaners and
hydrocarbons such as diesel, petrol etc.
Make sure that all open SimNet connectors are fitted with
a protection cap (part no 24006355).
Always put on the weather cover when the unit is not in
use.
6.2 Resetting the instrument system
The reset option will reset the instrument to default
settings.
The Installation and Setup procedures must be
repeated after a reset has been performed!
Maintenance |49