Operation Manual

Heading offset
The compass heading should be checked against a known
reference, a compensated compass or a bearing. If any
permanent heading offset is present, use the heading
offset parameter to compensate for the error.
Range Change per step Default value Units
-180 - +180 1 0 °
Rudder feedback calibration
The rudder calibration is used to compensate for any
non-linearity in the transmission between the rudder and
the rudder feedback unit.
Adjusting the maximum rudder angle
1. Start the calibration as illustrated below
2. Eventually adjust the maximum starboard (Stbd /
S.xx) and port (Port / P.xx) rudder angle
3. Press the Enter key to confirm the adjustments and
to finish the calibration as shown
Configuration |37