Unit installation

FS 70 Installation Instructions
974-24007001/4.1 49
“Click” on “Apply”. The following window will appear, overlaying
the above window, asking you to reboot the computer. Just “Click”
“OK” and do not “Reboot the computer now”; “Click” “OK” in the
“System Configuration” window.
To start the system, from the Operating Panel, position the mouse to
highlight “System Stop” located at the bottom of the panel, next,
left Click on “Stop” and a “Off, Stop, Run and playback window
will pop up. To start the System, position the mouse on the “Run”
bottom and Click.
4.3.8 FS 70 Run-up Procedure
After you click on the “Run” Icon, the system will automatically
detect and setup the sonar heads attached to the trawl cable. This
operation will take approx. 40 sec.
After the system Run Up is completed the best way to setup your
windows is to click on the separation window line and drag “Tile
Windows”. By clicking on the individual window, you can
rearrange, change the size, according to your preference.
The first step after a successful power up is to configure the system
for the desired “User Setting” operating mode and set-up, if not
already done; you will automatically select “Default”. Clicking on
“Default” or clicking on specific types of fishery does this. Refer to
the following window. From this point on we will be using the
Factory Default setting.