Unit installation

FS 70 Installation Instructions
974-24007001/4.1 31
4.2.3 Display Unit
Either an LCD/DVI or VGA monitor may be connected to the FS
70 Processor. Depending on which type of monitor is used, the
video output type must be set accordingly.
An industry standard VGA monitor will connect directly to the
miniature DB-15 connector located on the rear panel of the processor
unit.
The FS 70 Processor Unit has a Dual NVIDIA Quadro Video
interface card installed as standard equipment. You must set up your
display software as per your requirement. If you have only one
monitor, simply plug your monitor cable into the monitor “Y”
adaptor connector marked “Connector 1” on the adapter card. If you
are using two monitors, you must connect the 2
nd
monitor to the
“Connector 2” on the adapter card.
NOTE: The FS 70 Processor must be is turned “OFF” prior to
connecting the video monitors
A User Guide manual is provided with the system including a
Recovery CD-ROM. With this CD you can recover your system as
delivered and run the diagnostics.
NOTE: The Dual NVIDIA software is installed at the factory,
you only have to set up your monitor configuration as per
“Microsoft Window’s Operating System” provided with the FS
processor unit.
4.2.4 Power/TTM Unit
The Power/TTM Interface comes with the long line power supply
incorporated in one unit, thus making the installation easier.
The Front Panel comes with an ON/Off switch, trawl DC output
voltage meter, amperage meter and a four position trawl voltage
rotary selection switch. The possible selections are; “OFF”, “TEST”,
“120 V” and “200 V”. A “TEST/TRAWL” selector switch and test
cable connector is also provided in the front panel.
The Rear Panel of the Power/TTM Interface comes with 110/230
VAC power input, master ON/OFF switch and fuse located in the AC
power entry module, and RS232 serial ports “A”, “B” and “C”
including the 3rd wire trawl cable connector.