Unit installation

FS 70 System Operation
974-24007001/4.1 19
The next step after the above operation, for example, will be to add
a catch sensor.
Click on “sensor 5”; next select Door Spread or catch #2; next you
would select the channel of operation, in this case you would have
selected #2.
If you are adding for example a temperature sensor you can setup
an offset. See the windows above for the example.
Note: For additional information on the Simrad PI Setup, please
refer to your PI Instruction Manual.
3.2.6 PI 40 kHz Sensors Receiver Setup
The main “SENSORS RECEIVER SETUP” control panel allows
you to select the sensors you want to setup. To change the value of
the system parameter just left or right click the mouse over the
button you have selected, move the mouse up or down until the
desired button is highlighted and click the left mouse button or right
mouse button to activate the new setting.