Installation manual

SimradEK60
Note
Notethatthefourrubberbushingsmustbemountedontopofthebaserails.These
arerequiredtoprovidevibrationandshockabsorptionbetweenthebaserails,
andtherailsmountedonthecomputer.
Figure3InstallationoftheProcessorUnit
315.3
(433.5)
(36.7)
ø6.5
297.5
Rubberfootinsiderail
(CD031082-004)
5Mountthecomputerontothebaserails.
aHooktheunitontotherailsattherearend.
bPressitdown.
cSecurethecomputerwiththetwofrontbaserailscrews
Displaymonitorinstallation
ThissectiondescribestheinstallationoftheEK60ProcessorUnitdisplay.Themakeand
modelofthethisdisplayisdeterminedbythecustomer.Forthisreason,theinformation
providedhereisonlyforguidance.Foradetailedspecicinstallationprocedure,referto
theapplicabledocumentationprovidedwiththedisplay.
•Thedisplaymustbelocatedsothatitisbestprotectedfromglarewhichreduces
readability.
•Thedisplaymaybemountedinapanel,onthedesktoporbulkhead,oroverhead.
16
359619/A