Instruction manual

Instruction manual
20220513E 71
Display illumination colour
Activate the COLOUR display by pushing MODE. Use the
< or > button to select desired illumination colour. You may
select between white (W), green (G) or red (R).
Store selected colour by pushing MODE.
Push > to proceed to next menu item.
Boat type
The display will read BOAT TYP. The selected type of boat
will affect the steering parameters. Activate this menu item
by pressing MODE. The selected boat type will flash on the
display and can be altered by pressing < or >. You may
select between dISP (displacement), PLAN (planing) and
SAIL. Push MODE to store selected boat type. Push > to
proceed to next menu item.
Drive unit voltage
The display will read DRIVE VOLT. This menu option
requires the installer to set the drive unit voltage to the
correct level. The selections are 12V or 24V and should be
set to the voltage specified for your drive unit.
Note ! Selection of improper voltage level for your drive unit
may damage both the drive unit and junction unit even
if the protection circuits in the junction unit are
activated.
Refer to the drive unit table on page 49 for information. It is
not possible to select a higher voltage than the input
voltage. The CLUTCH/BYPASS voltage is automatically set
to the same as the drive unit voltage. The AP11 will also
automatically detect whether the drive unit is a reversible
motor or solenoid operated.
Activate the DRIVE VOLT display by pushing MODE. The
display will start flashing. Use the < or > buttons to select 12
or 24 V drive unit voltage.
Store selected voltage by pressing MODE.
Push > to proceed to next menu item.