Instruction manual

Instruction manual

20220513E 69

Press

EXIT:

STBY-AUTO

PWR

to select between menues

to access menu items

to change values on menu item

or acknowledge Yes or No

to store value on menu item

or to start a test or a calibration procedure.

to enter next menu

to exit Installation menu

MODE

Press

Figure 41 Menu operation principle

After the mechanical installation of the units it is necessary

to go through the installation setup to configure the system

to the boat and the steering system.

Before you start you should know the following: Type of

boat (displacement, planing, sail), rudder angle at hardover

position and at which transition speed you want the

steering parameter to be changed from HI to LO.

The installation setup menu is divided into two parts,

Dock-side settings and Sea Trial settings.

After having accessed the Dock-side Settings Menu, press

MODE to enter the first menu item in this menu.

Use the flow chart on next page when you perform the

settings in the Dock-side Settings Menu.