Instruction manual

Robertson AP11 Autopilot
68 20220513E
• The Installation Settings are available to both control
units in the system if there is a second station installed.
• The values in the Sea trial Settings are dependent on
successful completion of the Dockside Settings.
• Before attempting to turn on the AP11 and perform an
Installation Setup, the hardware installation and electrical
installation must be completed in accordance with the
installation instructions.
AP11 Installation menus
AP11 has five installation menus. Access to the menus is
achieved by pressing the two arrowed buttons
simultaneously.
Rudder Rudder Rudder Rudder Rudder
MODE MODE MODE MODE MODE
Dockside
Settings Menu
Sea Trial
Settings Menu
View Parameter
Menu
NMEA Check
Menu
System State
Menu
Press for
3 seconds
Figure 40 Installation menus
The Dock-side Settings Menu and Sea Trial Settings Menu
are for installation setup. The View Parameter Menu is an
information menu displaying the different steering
parameter settings used for the boat. It is also used if you
want to change any of the parameters.
The NMEA Check Menu and the System State Menu
display system data and are useful when trouble shooting
your system.
Operation of the different menus is based on the following
principle of push button operation: