Instruction manual

Instruction manual
20220513E 63
Ext.
alarm
TB6
J300X/J300X-40 JUNCTION UNIT
POWER PCB
TB7
TB8
TB9
Figure 35 J300X External alarm connection
LF3000 Linear Feedback
Note ! The rod of the LF3000 is not locked in place in the
cylinder. If caution is not exercised it may slip out of its
housing and end up over the side, so be careful!
The LF3000 is a waterproof feedback unit. It has a 300 mm
(11,8") stroke and comes with a special mounting bracket
which secures the LF3000 to the cylinder of the existing
outboard drive unit.
The 8,5 m (28') cable is terminated in the LFI3000 Mk2
Linear Feedback Interface according to the wiring diagram.
Center the drives. Loosely secure the LF3000 to the supplied
mounting bracket, across the center of the drive unit
cylinder. Either cylinder may be used if there is a dual set
up. You may mount the feedback in either direction, i.e. the
shaft of LF3000 may point to port or starboard.
Loosen the end bolt (a) used to secure the cylinder to the
drive unit mount. Insert the rod retaining assembly (b)
(end plate) and retighten this bolt. Secure the feedback rod
to the end plate using the two washers and cap nut
provided. Adjust the location of the LF3000 Linear
Feedback to allow full travel of the hydraulic cylinder
without causing the endplate of the LF3000 hitting the end
of the cylinder. Check that the outboard motor can be
tilted freely. Tighten all nuts and the mounting bracket.
Turn the helm slowly by hand to the stops on either side,
making sure that the rod does not bind up in any direction.
Also, clamp cable to allow full engine movement to port and
starboard. The mounting hardware provided with this