Instruction manual

Instruction manual
20220513E 59
3.13 Interfacing
With the AP11 autopilot system there are several
possibilities to connect to other equipment for data
exchange.
A further interface expansion is to connect to the Robertson
Databox to provide interface to IS11 sensors, Chart plotter
and GPS Sensor.
The NMEA output may also drive IS11 RUDDER and
COMPASS instruments directly.
The different connecting diagrams below illustrate the
interface possibilities.
J3000X NMEA input/output
J3000X includes a single NMEA input/output port.
NAV RECEIVER
OR PLOTTER
(NMEA talker)
NMEA listener
RUDDER instr.
COMPASS instr.
RADAR
RX1
RX1+
JUNCTION UNIT
MAIN PCB
DATABOX (NMEA Input)
Vbat+
Spare
Gnd
Red Wh
Bn
Gn Blk
TX1
TX1+
NMEA
Output1
Figure 30 J3000X NMEA input/output connection